Core E 400 Manuale delle Istruzioni

GasLessTM ELITE Trimmer E 400 Instruction Manual PRODUCT SPECIFICATIONS Power Cell: 36 Volt high energy Li-Ion Head spe

10 WARNING: Dust created by use of this product may contain chemicals known to the State of California to cause cancer, birth defects or ot

11 Do not use or charge the Power Cell if it is wet or shows any evidence of corrosion. WARNING: Leakage from the Power Cell may occur u

12 Use the charger only in a standard 100~240 V AC, 60/50 Hz electrical outlet. WARNING: Do not use the charger in wet or damp condition

V Volts A Amperes Hz Hertz W Watts H Hours Direct current No load speed Alternating or direct current Revolutions or reciprocations per m

14 Power head Battery AVAILABLE ACCESSORIES WARNING: Use only accessories that are recommended for this gasless

15 CONTENTS Carefully unpack the gasless trimmer. Compare the contents against the "GASLESSTM ELITE TRIMMER COMPONENTS" chart at right

16 ADJUSTING THE LOWER HANDLE The lower handle can be adjusted to suit the operator. 1. Using a Torx® screwdriver (1), turn the four handle cla

17 RELOADING THE BUMP HEAD WITH TRIMMER LINE – cont’d 4. Pull both ends of the line until an equal amount is extending from both eyelets (Fig. 4

18 OPENING THE BUMP HEAD TO RECOVER LINE – cont’d 2. Gently twist the bump knob clockwise to separate the two halves, be careful not to lose th

19 REMOVING THE BUMP HEAD – cont’d. 1. Follow steps 1-2 of OPENING THE BUMP HEAD TO RECOVER LINE to remove the bump knob from the bump head.

2 Product specifications ………….…………………………………………… 1 Table of contents ……………………………………………………………. 2 General safety warnings …………………………………………………… 3–4

20 INSTALLING A NEW BUMP HEAD WARNING: Avoid Injury! To avoid accidental start up: Always remove the Power Cell before removing or reinsta

21 MOTOR CONTROL SWITCHES To start the tool, push the lock-out switch (2) into the trigger (3), depress the trigger. To activate boost mode, s

22 For safety reasons, the operator must read the sections of this Owner’s Manual entitled "GENERAL SAFETY WARNINGS", "GENERAL POWER

23 INSTALLING THE POWER CELL Once the Power Cell has been fully charged and you are ready to start trimming, you will have to install the Power C

24 CUTTING METHODS WARNING: Be extremely careful when cutting around hard objects such as rock, gravel, fence posts etc. that can be conta

25 CUTTING METHODS – cont’d Trimming Position the bottom of the bump head about 3" (8 cm) above the ground and at a slight angle (Fig. 13).

26 CUTTING METHODS – cont’d Sweeping Use the GasLessTM ELITE trimmer for sweeping cut grass and debris from walkways and driveways. Position the

27 GENERAL WARNING: When servicing, use only original equipment replacement parts. The use of any other parts may create a hazard or caus

28 WARNING: When servicing, use only original equipment replacement parts. The use of any other parts may create a sa

29 CORE™ Outdoor Power - Limited Product Warranty Statement for E 400 GasLess™ ELITE Trimmer and Accessories Sold Only in the 48 Contiguous United S

3 ALWAYS WEAR EYE PROTECTION THAT CONFORMS WITH THE MOST RECENT ANSI Z87.1 or CAN/CSA – Z94.3 SAFETY STANDARDS. FLYING DEBRIS can cause permanent e

30 WARRANTY CORE™ Outdoor Power - Limited Product Warranty Statement for E 400 GasLess™ ELITE Trimmer and Accessories Sold Only in the 48 Contiguous

31 WARRANTY CORE™ Outdoor Power - Limited Product Warranty Statement for E 400 GasLess™ ELITE Trimmer and Accessories Sold Only in the 48 Contiguous

32 WARRANTY CORE™ Outdoor Power - Limited Product Warranty Statement for E 400 GasLess™ ELITE Trimmer and Accessories Sold Only in the 48 Contiguous

33 CORE™ Outdoor Power - Limited Product Warranty Statement for E 400 GasLess™ ELITE Trimmer and Accessories Sold Only in the 48 Contiguous United St

34 Instructions for Obtaining Warranty Repair Service or Aftermarket Non-Warranty Repair Service: To arrange for CORE™ Outdoor Power product war

35 a. The CORE™ Outdoor Power local authorized dealer determines that there is a non-functioning Power Cell, Power Cell charger, and / or CORE™ a

36 5. We recommend the package be shipped insured for full value utilizing ground freight. The recommended freight couriers for delivery to a CO

37 Can I have parts sent to me under the CORE™ Outdoor Power warranty? Unfortunately, we are unable to send out warranty replacement parts directly

38 CORE™ Outdoor Power Authorized Service Request Form Date:_______________________ Company or Institution Name [if applicable]: _______________

39 CORE™ Outdoor Power Authorized Service Request Form – cont’d Tool or accessory Model Number: _______________________________ Tool or accessor

4 BODY PROTECTION ELECTRICAL SAFETY PRODUCT SAFETY NOTICES – OWNER’S REGISTRATIONGENERAL SAFETY WARNINGS

5 GENERAL POWER TOOL SAFETY WARNINGS WARNING: Read all safety warnings and all instructions. Failure to follow the warnings and instruction

6 General Power Tool Safety Warnings – Personal Safety – cont’d Use personal protective equipment. Always wear eye protection. Protective equipm

7 General Power Tool Safety Warnings – Service Have your power tool or charger serviced by a qualified repair person using only identical replac

8 Cover as much of your body as possible to help protect you from debris and pieces of toxic and allergenic plants being thrown by the spinning li

9 WARNING: Inspect the area to be trimmed for hazards before each use. Remove any foreign objects such as sticks, rocks, broken glass, nai